English
中文简体
As a novice in decoration, it may not be very clear how to disassemble and install the shower head.But don't worry,I will give you a brief introduction on how to disassemble and install the shower head.
Disassembly method:
1.Determine according to the structure
Since there are many structures of the shower head,it must be determined according to the structure if it is to be disassembled.Because some showers can be disassembled only by turning counterclockwise by hand,and there is also a plastic welded nozzle,which must be disassembled with tools.
2.Use tools to disassemble
First,you will see the small round cover in the middle of the shower,and then use a flat-head screwdriver to pry it off.Usually,many shower heads can be disassembled,but the premise is that you must understand its structure.
installation method:
1.First find the connector
When installing the shower head,the first thing to do is to find the threaded copper connector,then wrap the two with a plastic bag, and then connect the reserved water pipe connector properly.It should be noted here that the installation of the eccentric joint should be controlled at a distance of about 15 cm,and then the installation height of the shower should be determined.
2.Install the eccentric joint
When installing the nozzle,it must be installed on the fixed seat of the eccentric joint.If the position is not right,adjust the eccentric joint.Note that a sealing washer should be installed between the nut behind the faucet and the eccentric joint.
3.Use skills to install
After installing the faucet,install the shower head to the elbow at the top of the shower rod,and ensure its stability,and then use a stainless steel hose to connect the faucet and the shower.After completion,check for water leakage,no water leakage means completion.
